Tweet
Hello guys i need your help before put back my stock esc to my trex 550, i fancy to try governor mode with my 550 and installed icecc 100, since then it produce an annoying chirping sound i try to fiddle gov gain setting frm low high nothing change i try to changed the with 600mx 1220 kv still the same no changes any ideas that you may came accross this solve this chirping sound thanks ....Ken
-
-
The two chirpings I had with my 550 were the motor bearings and the torque tube boom bearing, it also ate main bearings until I fitted thrusted ones but they never made a noise. Good luck hunting it down. -
The thing is its alright when i used the stock 70a escComment
-
The govenor gain is still too high, turn it down and the chirping should go away
Or if you have tried lowest setting turn it off and see if it is gone, then you can be sure it is the govenor
Comment
-
My current setting is 15 i try to use 5 the default still have the chirping sound but i never try lower than 5Comment
-
Have you got the correct PWM in the castle software for your motor ?sigpic
Rave ENV Nitro
New Logo 550
Synergy N5c
TSA 700E night flier
I use VBar control because it's feckin awesome I use NEO rescue when I remember to
5 x EGS thingys and a Platinum star doo dahComment
-
My motor before is 600m1220 kv now i replaced that with 600 mx 1220 kv my setting 8 khz on pwm i try 12 khz chirping still exist and i put back again to 8khz correct me if this wrong i put 6 pole on the setting on this motorComment
-
More than likely the motor bearings, try oiling them up and see if it goes awayJames
Sponsored by
Align-Trex.co.uk
Optifuel/optipower
MKS servotech
5 Eddie gold stars and christmas starComment
-
Do you have the Castle link, if so post the settings your using.Paul.
2 x TDR II Bavarian Demon AXON, Pyro Comp 850/50, Kosmik cool 200, Futaba BLS, 15s
TDR Bavarian Demon 3X, Pyro Comp 750/56, Kosmik cool, 14s, Savox: SB-2282SG, SB-2283SG Tail
TDR Bavarian Demon 3SX, Pyro 750/56 comp Kosmik Cool 200, Savox,
Logo 600SE, Bavarian Demon 3SX, Pyro700/52, 80HV,
Logo 480 xxtreme, Bavarian Demon 3SX, Scorpion, Savox, YGE,Comment
-
I know the 600MX 510kv is a 10 pole motor. Not sure about yours thoughOriginally posted by aviatech22 View Post
Very proud to be an Align-Trex.co.uk Team Pilot!
SABGoblin 700 / V-Bar Blueline 5.3 Pro
Trex 600 EFL Pro / V-Bar Silverline 5.3 Pro
Trex 500 FBL / Beast X
Futaba 8FG
Proud Owner of 2 EGS Awards
Comment
-
Its 6 pole for 600mx 1220kvComment
Comment