Newbie honey bee king2 help setup - inc Video

[lee_m]

Hi peeps
Id like some help please!
Ive bought this heli, i had to replace the two back servos and do i general gyro setup ect..
Ive never done it before for and all the info i know is though YouTube.
but i have a few issues and i dont want to try and hover it till i know its setup right, so ive done a few videos to help you kind please help me.


Swashplate video
Honey bee king2 swashplate - YouTube


Gyro and Rudder video
Honey bee king2 gyro and rudder servo - YouTube


Throttle and Rudder control and a homemade turn table
Honey bee king2 throttle and rudder - YouTube


Aileron and elevator movement
Honey bee king 2 Aileron and elevator movement - YouTube


I have tried to get the heli and the controller in the video so you can see what im doing and how the heli is reacting


This is my first 6ch heli, been looking at getting one for a few months, then this honey bee king2 came up for sale it has all the mods on it except the brushless motor, i will buy this when i can hover it or this motor dies LOL
the heli came with enough parts to repair it 3 times when i crash it! blades ect.. and it came with the flight case


HELP!

[dieselcarb]

Ok on ya left stick up and down swash should go up and down. On right stick swash should tilt what ever way you move stick and your better off not spinning up blades when your face is a foot away

Sent from my GT-I9000 using Tapatalk

[dieselcarb]

Also just incase they not all swash servos must be identical

Sent from my GT-I9000 using Tapatalk

[lee_m]

Ok on ya left stick up and down swash should go up and down. On right stick swash should tilt what ever way you move stick and your better off not spinning up blades when your face is a foot away

Sent from my GT-I9000 using Tapatalk

I thought that! when i swop the direction of the throttle the motor does not work, any thoughts on this

thanks for the reply

[spudly]

Yes it looks like your elevator (right stick up and down) is controlling your pitch and your pitch is controlling your elevator.
Do you have the servos plugged into the correct channels on the RX?

[lee_m]

thank you you may be right i have another video ive just done Honey king2 - YouTube
I have it set like this

Channels as per factory set up are:
1. Aileron (port side back servo)
2. Elevator (front servo just behind motor)
3. ESC
4. Rudder (tail servo)-> gyro->receiver
5. Empty (used for HH gyro)
6. Pitch (starboard side back servo) I have no idea why Esky calls it "pitch"
batt: empty



think i'm using mode 2????

[lee_m]

Spudly.. your right!!!!!! i had the two rear servos in the right ports but i got the left and right wrong it all works as it should now! i'll do another video tomorrow just so you can all check?

thanks mate