Align 3 problem HELP

[bazone]

Can anyone help with Align 3g set up ???? Using a DSX9, 120 CCPM x 3 servo set . inhibited switches not needed with device select, got swash mix 60% aileron. -60% elevator and 38% pitch which gives me + - 12deg collective and 10deg cyclic .Using a RJX head . Elevator servo (3) plugged into elev on receiver. aileron (2) plugged into aileron on receiver, pitch servo (6) plugged into aux 1 on the receiver. this configuration works fine as I flew it when it was flybared. I then removed each servo lead from the receiver and plug them into their respective place in on the Align 3G unit and plug the cable output from the 3G back into the receiver each cable into its respective place in the receiver. When I power up holding the set button the five leds scroll but the odd thing is that the status light flashes green /red a couple of times and then goes to green at this stage the unit is in DIR mode and works perfectly everything is mechanically set up. I then move the swash plate to 0 deg and press set, keeping the throttle at mid stick (0 deg) i move the elevator forward and then back to centre press set to go into E Rev in order to test gyro sense and the swash plate goes into full pitch and stalls the servos and nothing else works,can you shed any light on what I'm doing wrong

[igottomanyhelis]

double check its the right swash setting in tx ,ive just had same prob my futaba tx has two different setting and i had the wrong one.mine did the same as yours