Scorpion 5025 440

[Jamin_00]

By looking at these stats Scorpion HK-5025-440KV - Scorpion Power System is anyone able to tell me how it would compare to the 4035 500??

Scorpion HK-4035-500KV (6mm Shaft) - Scorpion Power System

[Sieze2]

By looking at these stats Scorpion HK-5025-440KV - Scorpion Power System is anyone able to tell me how it would compare to the 4035 500??

Scorpion HK-4035-500KV (6mm Shaft) - Scorpion Power System

The 5025 is a higher wattage motor, which is heavier, and 1cm wider. You can't easily use them in a 700E without cutting the frames and making some kind of bridge becasue they are so wide. Will they fit in a kassama 90E?

[Swashbuckler]

I pretty sure I tried one on my 700 conversion Ben, it was no good for 3d if it's the same one. Besides I think the outside diameter is too big for the srimok e. It will foul on the special elevator arm. I still have it at home so I can check for you tomorrow. Think you are better off with the Kontronic or the Scorp 4035 series.

[5exi]

Think you are better off with the Kontronic or the Scorp 4035 series.

If you go for a bigger motor you may start ripping up main gears which is fine if your only paying £10.00 for two

Or a KDE Direct 1917H-N42 HP motor

Fast Lad Performance

Good thing about a 4035 or any scorpion motor is there easy to repair i'e shafts etc

Another one to look at is a 4030/3y-470