Align governor settings

[derrick]

Hi all just fitted an align governor in the velocity did the straitforward settings.
not sure what settings to use in the tx it's a futaba7c 2.4. engine os50 hyper
Has anybody got any idea where to start, i just have no idea having never used one.
Still learning so it's only for basic flying.
Cheers Del.

[Steve]

Could be wrong here, but I seem to remember the instructions give suggested values for different transmitter types for the TRex 600 - just try those for starters.

[J-S-Q]

Could be wrong here, but I seem to remember the instructions give suggested values for different transmitter types for the TRex 600 - just try those for starters.

I tached my 600 and the head speed came out pretty much bang on the figures stated in the manual.

[trexaddict]

Again go with the setting stated in the instructions they ar e fairly spot on

[Tom Burgess]

They wont be spot on on the Velocity due to the 8.6:1 gear ratio. The manual references 8.5:1 for the 600 so some math can be used to calculate the required endpoint value juts like you do with the 700 which is 8.2:1 ratio

[trexaddict]

i think im right in saying that you need to mutiply target head speed by gear ratio ie head speed 1900 x 8.6 = 16340 so you would need to set your atv around 75% if im wrong sombody will tell me but i dont think i would be that far out as the last one i done on a 7c was around this hope this helps mark