Vision 50 Competition Mixer Arms

[callum]

Hey Guys!

Going to get my blade pitch sorted, but noticed at mid stick that the mixer arms are not quite 90 degrees and are bowed down a bit,

can someone please confirm that they should be 90 degrees or atleast level at midstick,

also, would it be possible if someone could upload a pic of there head setup at mid stick? that would help me out a bit

Regards
Callum

[Tom Burgess]

mixing arms like the ones on the vision 50 shouldnt be at 90 degrees. The long link going from the swash to the arm should be at 90 degrees to the arm. I will try to find you a pic

[Dannyyy]

I'll have a look in a sec...

[Tom Burgess]

See the pic below. Now because of the angle it does not look 90 but basically on a head with arms like that, the long link and the arm need to be at 90. Does that make sense?

[Tom Burgess]

lol, there was one in the Aurora manual all along

[callum]

Hi Tom!

Re-adjusted the swash to flybar carrier links:



i didnt have the flybar level when i took the pic, but when the flybar is level its 90 Degrees

[Tom Burgess]

Thats more like it. Now adjust blade tracking using the short links

[callum]

Thats alot better now! Never knew that the long link and the mixer needed to be 90 degrees to each other!

After making that change both blades are now at 0 center, +14 and -8 so just need to edit the config in the cyclock and should all be set

i fancy 13+-

[Tom Burgess]

Thats alot better now! Never knew that the long link and the mixer needed to be 90 degrees to each other!

After making that change both blades are now at 0 center, +14 and -8 so just need to edit the config in the cyclock and should all be set

i fancy 13+-

Not as simple as an Align heli Callum

[callum]

Not as simple as an Align heli Callum

Oh dont i know it! haha,

Even tho the head looks alot more simple, it sure is not, well for me anyway!