Glue for foamie

[challis349]

Hey guys, need to glue a cracked fuse and a new tail fin on my micro Su 26, don't know what to use, hot melt glue will be ok on fuse, but not to secure tail, what glue are you guts using :cheers2:

[Nick B]

foam safe super glue or uhu-por ;)

[challis349]

Uhu por it is then, b and q by chance? Or specific hobby stuff?

[Boggy]

selotape and foamsafe ca Kev! Hot glue is a little heavy for the sukhoi:)

[challis349]

I'm new to this mate lol, where can I get foamsafe ca? Thanks guys

[chris jones2.4]

when replacing my motor in mine, i used hotglue first but it was a bit crap so then used silicone and that was crap so i pulled the epoxy out lol

[Nick B]

[url=http://robotbirds.com/catalog/product_info.php?cPath=292_76&products_id=1104]Robot Birds[/url]


[url=http://robotbirds.com/catalog/product_info.php?cPath=292_76&products_id=1102]Robot Birds[/url]


[url=http://robotbirds.com/catalog/product_info.php?cPath=292_76&products_id=1092]Robot Birds[/url]

[challis349]

[QUOTE=BladeStriker;676715][url=http://robotbirds.com/catalog/product_info.php?cPath=292_76&products_id=1104]Robot Birds[/url]


[url=http://robotbirds.com/catalog/product_info.php?cPath=292_76&products_id=1102]Robot Birds[/url]


[url=http://robotbirds.com/catalog/product_info.php?cPath=292_76&products_id=1092]Robot Birds[/url][/QUOTE]

Cheers mate

[Boggy]

Maplins do it if you have one close by(foamsafe is slow drying so take care holding it straight.)

[bikerflier]

Found UHU por too rubbery and flexible. Any stressed areas bend under load when using this.
Foam Safe Superglue and Foam Safe Kicker (activator)
Local model shop should stock it.
Not the sort of thing B&Q have.
Several options here.
[url=http://www.fast-lad.co.uk/store/index.php?cPath=47_142]Fast Lad Performance[/url]


[QUOTE=challis349;676704]Uhu por it is then, b and q by chance? Or specific hobby stuff?[/QUOTE]

[challis349]

Cheers guys, will go look at maplins, have ordered some from nick links too :cheers2:

Good job I ordered an extra one for parts :D

[Planehazza]

if it's polystyrene or the stuff that makes the RC Factory yaks, regular CA is fine, just don't pour it on obviously.

[rcthrasher]

I use gorilla glue - but like expanding foam, really easy to sand andyou dont waste as much as epoxy

[rcthrasher]

Or just heat up epoxy so it's really thin