where battery connection at 6ch receiver? no free slot anymore

[FuturaSE]

Iv asked this before but i lost the answer in my head and in my threads

I do have a 6 channel receiver like this:

default.jpegdefault2.jpeg



but i do need all channels for the servos and gyro, so where to connect the battery?

was it something like i do have to use a Y or V cable? and if, at what channel?

tx

[FuturaSE]

did find the thread and solutions:

Mark_T: "You don't need a 'channel' for the battery, just use a Y lead into one of the others."

Trillian: "You can do it one of two ways. 1. connect everything and use a Y lead to connect both the battery and bind plug into the battery / bind socket. Or 2. disconnect something temporarily and use a channel for the battery and the bind plug in the bind socket. Then once you have done the bind you can remove the bind plug and connect the battery in the battery/bind socket.

Make sure when you bind it you have the throttle at zero, or what I do is use throttle hold when binding. Keep in mind you can always do the bind, then setup everything as it should be and then re-bind later."

>> so im going to use an Y cable and use it on channel 1

[johnsandywhite]

As above. 'Y' lead. You could even use it on the Throttle channel.