700N and AR7200BX setup help.

[pjbrazendale]

Hi,

First time setting up the AR7200BX from scratch everything is hooked up and I have reset the unit to factory defaults as it came out of my 450X. I have set all the servo frequencies etc and tail frequency now onto setting up 0 pitch on step G. What I want to know is what throttle and pitch curve do I run when doing this? Also should I be ad mid stick in normal mode or idle up for 0 pitch, if someone could point me in the right direction I would be appreciated! Also a little of topic tried to get Rapicon 20% for my heli however couldn't get it so got opti 20% for my OS91HZR 3D will this be ok? Also my tx is a Spektrum DX7S. Many thanks

[tonystevens]

You need a straight line pitch curve pete 0-100% throughout the set up. You can change that once youve finished. Doesnt matter about throttle curve.
dont worry about stick position as the beast x puts the servos at the centre position for you at menu point G regardless of where your stick is

opti will be fine but you can get rapicon at the shop behind our club field

[Raving Jim]

Hi for setting up your pitch in the beast x you need a standard straight line in your transmitter , the beast will automatically go to the midstick position for you so don't worry bout the stick, set the swash level then set your plus an mminus pitch , of course when you are in the menu setting swash level your blades need to be zero on the pitch gauge.

[pjbrazendale]

You need a straight line pitch curve pete 0-100% throughout the set up. You can change that once youve finished.
dont worry about stick position as the beast x puts the servos at the centre position for you regardless of where your stick is

Cheers Tony, any chance you could post up a pic of your 700n wiring also as interested on how you route the wires. Cheers

[tonystevens]

Here you go

[pjbrazendale]

Here you go

Cheers!