Electronics Wizard Help please....

[kylelnsn]

I am looking for a bit of advice with wiring up some LED's

I have a basic LED RGB kit from HK.

I want to run it in two different directions so see the image below that is were the connection comes in.
photo(4).jpg
Now my question is can I cut the strip below at the appropriate length and then run a small piece of wire from the connections above so they match the piece below? Then I can run each strip in opposite directions but run them from the same rgb unit.
photo(3).jpg

I hope that makes sense... cheers!

[Gav]

yeah - just snip and wire it up from the same rgb unit, so it matches the other piece. Should be fine

[kylelnsn]

yeah - just snip and wire it up from the same rgb unit, so it matches the other piece. Should be fine

EPIC! Thank you! I thought it would be ok but thought i better check!

Cheers! better polish off my soldering skills that have been sat on the shelf.