AR7200BX Tail wont hold ?

[SamS]

The tail on my 450x won't hold for some, it was fine yesterday, but today it wont hold.

Seems to be bad when I punch the collective, I tried a flip today and the tail just span.


All settings are neutral on the AR7200BX, I havn't adjusted them, and I didnt change the gyro gain on the TX.

I even increased the gyro gain on the tx to 78.0 and still it won't hold.



Anyone suss this out ?

[Jez N]

Here a link to HF post which i used to set up my beastx. Follows a nice order and easy to understand.

Blade 450 X Setup for Success - Page 2 - HeliFreak

[tonystevens]

if you havent changed anything in the tx or beast x it must be either mechanical or your tail servo is on the way out.

[exiged]

as above.disconnect your tail push rod and make sure the slider is smooth as silk.Other than that id re-check set up and try another tail servo.

[SamS]

Thanks, I will read up on it