Futaba Tx Stick Not Centred

[dani_r]

Can anyone help with this?

Just got my friends new FF7 delivered but it was mode one. I've taken all the necessary gubbins out of the other side and transferred them over but now the new elevator stick isn't centring correctly. I can't see any place for adjustment, only on the tensioner springs.

Any ideas how I can get it to centre?

Cheers

Dan

[Mslater]

Dan,

do you mean the stick not springing to centre or the channel is not at centre on the monitor.

Can you post a pic ?

[dani_r]

Dan,

do you mean the stick not springing to centre or the channel is not at centre on the monitor.

Can you post a pic ?

Sorry buddy. I thought I did! Must've cocked up somewhere.
Pic to follow....

[dani_r]

[Mslater]

Did you take the stick out completely ?

It may be up side down.

Other than that, for what it is I'd probably just trim it out with a little sub-trim should the channel be off centre. The problem is you'll nee something to monitor the output from the RX. Are you using it on FBL ?

[dani_r]

I just took the spring and plastic arm that goes underneath out and moved it to the other side. Can't figure out why it wouldn't be centred.

[Mslater]

It probably never did. I'd just trim it out.

[JoeBailey]

My 10c sticks are the same but they centre perfect on the vbar setup and on Phoenix.

Joe