Tweet
Not sure where to post this so thought id put it here.
My DX6i/500 efl / 70a align esc seem to be ignoring the top 30% of my throttle curve.
Normal curve is set at flat 80% (Except low throttle obv). Idle up V curve flat 90% with 100% at top stick.
If i spool up to normal mode 80% with no blades, then flick idle up, no RPM change. Go top stick, still no rpm change. Monitor shows the throttle channel changing.
In flight its the same story too. I used to have a 70% throttle curve for standard and its still ignoring the change in throttle.
It used to change when i flicked idle up...what gives? Ive even tried getting rid of helicopter mode and just sticking it on glider mode, as I know the governor reserves 10% power, I thought this might be factoring (Even though im not acutally using it!)
I really dont get it...anyone else had this?
My DX6i/500 efl / 70a align esc seem to be ignoring the top 30% of my throttle curve.
Normal curve is set at flat 80% (Except low throttle obv). Idle up V curve flat 90% with 100% at top stick.
If i spool up to normal mode 80% with no blades, then flick idle up, no RPM change. Go top stick, still no rpm change. Monitor shows the throttle channel changing.
In flight its the same story too. I used to have a 70% throttle curve for standard and its still ignoring the change in throttle.
It used to change when i flicked idle up...what gives? Ive even tried getting rid of helicopter mode and just sticking it on glider mode, as I know the governor reserves 10% power, I thought this might be factoring (Even though im not acutally using it!)
I really dont get it...anyone else had this?
Comment