If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I got fed up losing links on my MCPX, and after reading a thread on how to keep the links on by using an elastic band, I thought I would give it a go. Bish Bash Bosh! works great, no more lost links. Thanks for the info
EVO 180
MCPX Storm 400 rebuilt again!
KDS 450
Mini Titan V2
DJI Phantom fc Big Steve
This works well and causes no damage either what i have done is tethered both links to each other using thread can also use thin fishing line 90% of the time only one pops holding the other so it is no lost you could tipex them both white so if both do pop they stand out.
Liam
Sent from my iPhone using Tapatalk
Taort 450 pro v2 fbl
mz18
proud owner of 2 egs
sponsored by :
KBDD International Pilot
I just put i tiny bit of hot glue over the gap . Havent lost any links in the 3 inverted crashes ive had but i did break the rear ball link off the swashplate.
Anthony
Trex 470LP , Devil 380 , Invertix 400 3D Quad 4S , MCPX BL , 180CFX , Next Sim
I used two pieces of cotton thread and CA glue to close out the gap, waited for the glue to cure then trimmed to fit. Works a treat not lost a link since
I try anything if there is going to improvement, I've not tryed the invert as yet with this elastic mod?
Previous Invert the links keep't popping off, I will try the hot glue looks like a better fix
EVO 180
MCPX Storm 400 rebuilt again!
KDS 450
Mini Titan V2
DJI Phantom fc Big Steve
Comment