servo y leads?

[sunny_manku1985]

Hey guys, I am in need of purchasing a servo y lead for my logo 600. The only ones i can find are around 150mm long, which is just too long!.lol. I need something around the 50mm or 70mm mark. Any ideas where i can get this from?

Also looking for some carbon sheet.

Would be grateful if somebody could point me in the right direction.

Thanks in advance.

[tonystevens]

Is this for your buffer pack sunny?

[ModelGuard.Com]

Servo Shop

[sunny_manku1985]

@ tony - no its for running the slave lead of my kontronik to split with my rudder channel. I am not running a buffer pack yet.

[sunny_manku1985]

@ modelguard - there doesnt seem to mention any length on this lead?

[ModelGuard.Com]

70mm Futaba servo mini Y lead / splitter - UK seller | eBay

[tonystevens]

@ tony - no its for running the slave lead of my kontronik to split with my rudder channel. I am not running a buffer pack yet.

Ive got my slave lead plugged straight into the v bar, neater option and you should be able to do it too?

[ModelGuard.Com]

@ modelguard - there doesnt seem to mention any length on this lead?

looks quite long maybe 150/200 mm but its only one lead with a double socket

[sunny_manku1985]

Not in stock on the ebay link :-(

no tony, I am using sbus, so all my channels are taken up on the vbar, and as rx a is a signal only channel, i can not place it in there either

[tonystevens]

ahh i see.

[ChrisB]

I Normally cut mine down to the reqd length and re plug them.

[sunny_manku1985]

Thanks Chris, but I dont have the crimping tools required, would like to get something off the self if possible

[ModelGuard.Com]

JR Y-Lead 10cm x 5pcs

100mm

[sunny_manku1985]

JR Y-Lead 10cm x 5pcs

100mm

thanks model guard! Think that will have to do the job.

anybody have any ideas for the carbon sheet?

[ModelGuard.Com]

thanks model guard! Think that will have to do the job.

anybody have any ideas for the carbon sheet?

last time i looked carbon sheet was quite expensive