align esc and throttle setup end points

[loz]

im in the process of converting my 450 sport to fbl using align 3g system, unfortunately iv just fried my rx and possibly my esc, and before i replace them and blow them up again can someone tell me the correct setup procedure of an align rce-bl35g esc (not the setup of beeps i know how to do that) so that i have full range of throttle i.e. how to set the end points so im getting the most from the motor, cheers loz

[Gingerr6]

I think what you want is.... put throttle at full. Connect battery to esc wait for the beeps then reduce to low throttle. ????

[bikerflier]

Pretty sure that's the only way to set the end points on Align esc.
I've had loads of them and never known any other way to do it.

I think what you want is.... put throttle at full. Connect battery to esc wait for the beeps then reduce to low throttle. ????

[heliboy]

Nobody cares

[Chris Boughton]

I think what you want is.... put throttle at full. Connect battery to esc wait for the beeps then reduce to low throttle. ????

Yep that is the correct way but make sure the throttle curve is set to linear (0%-25%-50%-75%-100%) Otherwise it wont setup correctly!!