Problem with KK multi Black

[Mslater]

Since I put the KK Blackboard on the quad it's been horrible.

I started with V4.7 in X config
Tonight I've re-configured and loaded V2

The same problem exists in both versions.

From power on, gentle acceleration produces a stable hover, all gyros working correctly and very stable.

Any increase in throttle and it veers off left. The more throttle the more violent it veers off.

Now this is the bit I really don't understand...

After its had a jump left the stick centres are way off - I have to hold in 80% right stick with 40% back stick and a load of rudder to get back into a hover.

It stays like that until power off - power back up and really stable again sticks at centre.

The problem is consistent and happens every time any amount of power is applied.

Suggestions would be welcome - I've been fighting this for a few weeks.

I've been through the TX and checked the output monitor for mixing etc.

[Gaza07]

v2 is minsoo kims firmware and has a stick centering procedure HERE if you have already done this then maye try a fresh model memory to make sure there isnt anything wrong there and recalibrate your esc,s other than that it sounds like the board may have gone faulty

[Mslater]

v2 is minsoo kims firmware and has a stick centering procedure HERE if you have already done this then maye try a fresh model memory to make sure there isnt anything wrong there and recalibrate your esc,s other than that it sounds like the board may have gone faulty

Starting to go with the board fault theory - it was bought 2nd hand

[Gaza07]

The KK controllers arent to expensive now to replace you can get one from hobby king cheap although they only have a atmega48 on them so wont run v2 but will run v4.7,
Or you can get the new KK plus 5.5d board that has just come out cheaper than HK from HERE, there is also a lcd setup screen available for it so you can alter settings at the field, the forum for this board is HERE there is a bit of a waiting list for these but he is getting through it quite quickly, you can run any firmware on this board but there is a firmware written for it by mike barton that supports the lcd and control loop setup