Blade tracking

[Brod]

Hi,my Knight 3D blade tracking is out about 3-4mm after repalcing the ball links recently.
Turning one screw on one of the blade holder to mixing arm makes it track the same mm the other way,what do you guys do in this case?
obviously 1/2 turn would do it but would make one of the links fit backwards on the ball.

[nicobec]

I have always just but it in backwards. They are a bit tight but no trouble with my trex450.

[Eckchaz]

DONT put the link on backwards.. they are designed to go in one way and work one way ;-)

To get a half turn.. follow the link that needs adjusting down to the mixing arm.. and the link on the other end of the mixing arm will connect to the swash... it is that link you adjust.. a full turn again is what you need. That full turn on the link equates to a half turn on the main blade link

[Brod]

I'll have go at that,been out of helis for 4 yrs,just got back and kinda forgotten the little things.lol

I'm a perfectionist with setup so need to get it right..