Dynatron wand(fit)?

[Chopper07]

*At your own Risk*!:-)

Hi,For what it is worth, I have used Dynatron with sullivan heli wand using 2xold3s lipos from my mini Titan (=1x6s) for 2 years without incident! Always works great. The most robust system I have seen though not the lightest!If you have an old 5S great but if not I wouldn't go out and buy one just for the job personally. It might make a difference that if I get a fuel lock I shake the heli a bit while tilting it towards the exhaust side then hey presto. But I have never damaged anything and I don't have to take the plug out anymore, (although if it was really stuck that would avoid any danger of damage).No more struggling with starting = More time flying ! happy days:-)P.S. just putting 2years experience into the pot, what you decide is at your own risk if you think there is any.

[Jamin_00]

I used an old 6s pack and it was still over kill.

4s or 5s is the way really.

[Cuppa]

I have said befor imo directly driving the wand from a dynatron
or any starter with balls! is not good the ball on the wand will
eat the starter cup/damage one way, f#ck the clutch stack double quick If you remove the cup from the starter it is a pig to put back on
and imo should not be removed. i do not use the ball end anymore
i have found the hex end much better, but you must take off the sharp
edges on the wand with wet n dry paper or it will stick in the cup! not
good!! Having the wand pushed into the rubber in the cup on the starter is much kinder to the clutch stack

[sacko]

Is that a relay on your Dynatron?

I presume it is to stop it welding the switch, does it work?

[Cuppa]

Is that a relay on your Dynatron?

I presume it is to stop it welding the switch, does it work?

Yes and yes relay's from motor serv works a treat mate

[sacko]

May have to fit one on the next Dynatron, as the switch welding is what ruined my last one... Doh.

[Cuppa]

If you use one of these relays your welded switch days 'l' be
over thay are as cheap as chips and dead easy to fit.
relay on pos side through the switch.

[Nick B]

OMG,how good is this starter

10 seconds from switch on and the 700 was running.....off 12v no probs...chuffed to nuts