Servo Crimping Favour Needed

[sacko]

I need to change a male servo connector to a female one for the power switch on the Velo.

I dont trust myself or my crimps tbh, I have all the pins and plugs.

Dont suppose there is anyone who has done this a few times who could help me out?

[GravityKills]

there is a simple solution: Get a servo extension, cut it in the middle, and solder one end to the wire where you cut off the old connector.
Use thin shrinking tube on the individual leads.
This solder job is about as easy as it gets.

I would not trust any crimp joint that isn't done with industrial-grade equipment.

[Rctintin]

I solder my crimps Paul, Just not happy having a dry joint on those pins.

Only use a tiny amount of solder with a fine tip, and then long nose plyers to bend over the tabs sticking up.

[sacko]

Fancy a job Rob?

[Rctintin]

Send it over with the 610 and I'll sort it buddy

[sacko]

You're a gent