K&S starter shaft oneway bearing help

[F.arch]

Anyone know where I can get one of these? And how to change them; heat or bench press?

Some where I've read that you can use a better bearing anyone done this mod?

[sacko]

Drill it out and stick one in from RCBearings

[F.arch]

K & S starter shaft replacement bearings

Anyone know where I can get one of these? And how to change them; heat or bench press?

Some where I've read that you can use a better bearing anyone done this mod?

Update: don't drill them, just apply a little heat and they knock out easy. then get a one way and plain bearing from:Simply Bearings Ltd ~ Oil Seals SKF FAG TIMKEN KOYO NTN NKE TRULOC Needle Rollers Taper Rollers Rod Ends Oilite Bushes Loose Balls O Rings Grease Plain Thrust - Simply Bearings Ltd ~ Oil Seals SKF FAG TIMKEN KOYO NTN NKE TRULOC Needle Rollers Taper R (good for OS rears too) (see image below for ref). The bearing for the shaft is not easy to get, just use a stand one-way for a 10mm shaft, the spec for this is better than the original bearing (more torque) this then fits inside the plain bearing, press this into the alloy housing first with some red bearing seat, a nut, bolt and washers can be used to draw the bearing in. then do the same with the one-way, again using red bearing seat, check that it's the right way around. so far this has started my YS91SR no trouble

Cost £9.62 inc VAT and post!

[F.arch]

Found

Still working! For the person looking for it!