Dynatron + K&S Wand..

[sacko]

How is everyone fitting theirs?

I used the red sleeve that comes with it, attatch it to the starter then clamp it up, but as soon as I try starting anything with it the wand un-screws itself off the shaft?!

Anyone tried pinning it using the hole provided? What drill bit is best as that shaft looks pretty tough!

[Si_B]

Red Loctite or bearing fit stuff, put a load on and leave it. Will not come off after that.

If you need to remove it at a later date, just apply a little heat

[daren]

[sacko]

Sounds like a plan to me, but does the red loctite work on plastic?

Drilling that shaft looked like a mission.

[SLIPPERY STEVENS]

get yourself a cheap one like mine.. always a winner... ha ha

[sacko]

Pah.. Wait till next weekend sunshine

[Si_B]

I thought the K&S wand was metal ??.

[sacko]

It is, but there is a plastic insert inbetween the wand and the Dynatron shaft.

[boxy]

i have a simular issue but mine is with the power tourque 2, came in box with rubber grip and shaft holder, the drama is everytime i go to use it it just spins the shaft holder out of the rubber cup, it court me on the finger today well hurt

[sacko]

Thats the red insert that goes between the starter shaft and the wand.

[Si_B]

Is it not threaded as well ??. Surely its not just the clamping force holding it onto the shaft ??.

[sacko]

Nope its not threaded at all, yup just clamping force which really isnt ever going to be much

Have a feeling im going to have to pin it and use the pillar drill at work.

[Si_B]

Depends if the shaft is hardened I guess. Pillar drill would be a good bet, at least you should be able to drill it square.

I can't believe its not threaded, might as well use a push in one.

[sacko]

Looks fecking hard to me

[crash-alot]

I drilled my dynatron shaft with a dremel drill, so can be done.