If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
i always work on my helis with a white rag underneath them, it stops tiny screw etc bouncing around when the fall...
Sounds like a good idea to me.
Pico z * 2 (I know they arent 'proper' helis but they are to blame)
MCX - Got bored after a fairly short time.
MSR * 2 (my current favourite)
SR -as yet unflown
Well, yeah, I'd spotted that. I thought perhaps I'd missed something. That it had some magical qualities.
Perhaps it's a magnetic towel that attracts runaway screws? Perhaps it buzzes if you've not threadlocked a fastener? Or maybe, just maybe, you lay all the parts and tools out on it and, just before you go to bed, you utter the magic words and wake to a fully assembled and rigged T-rex?
This is not just any towel. It's an Align towel!
Martin
Most of the Aligns, fair few Spektrum bits, bunch of Align & HiTec servos, OBE, VD & Bar.
It's mainly for laying under the model when you working on it so small screw don't bounce off the table in to the grass/carpet never to be seen again.
Worth it's weight in gold almost and as Janek pointed out you buggered for flagging down a Vogon ship with out it (if any one doesn't get that bit then don't ask just go hang your head in shame some where!)
Comment