clutch liner

[brin]

just replacing the liner in my rappy .what glue do you use as i have never changed one before dont have a clue also can anyone point me in the right direction for a manual for an os 32 ringed.

[Tim Procter]

Standard super glue I use Brian.

Wrap some electrical tape "once" round the clutch and engage it in place once you have fitted the liner in the clutch bell.

It keeps the whole thing in-tact while it dry's and settles.

[Spurry]

I use 24hr Araldite epoxy for clutch liners.

Pete

[Asid]

Hi

Roughen up the inside of the bell and the outside of the liner

Use epoxy to bond. I use JB weld.

Wrap the clutch shoe with a couple (some use 1 layer) of layers of electrical tape and put inside the bell. This will keep the liner pushed out ward and help set a proper gap.

Hope this helps.

[Dannyyy]

J B weld i used

[Tim Procter]

I use 24hr Araldite epoxy for clutch liners.

Pete

Much better than super glue.

My stuff goes off too quick.

[debrooker]

just replacing the liner in my rappy .what glue do you use as i have never changed one before dont have a clue also can anyone point me in the right direction for a manual for an os 32 ringed.

funny you should mention this, i've just done mine 5 minutes ago.

I've used epoxy to 'glue' mine in and as mentioned wrapped insulation tape around the clutch and inserted it into the bell to add a consistent pressure all round. I have to wait a little longer for the epoxy to set (24hrs)

[gazelle341]

The OS32 manual can be down loaded here:
O.S. Engines Product Manuals

Its about a third of the way down the LH column

Cheers
Mick

[brin]

should have waited untill i read all the posts,superglued and taped many thanks all.the reason i was asking about the manual was i have a problem with the carb i think .just running in the 32 so set the adjuster at three and a half turns out and the bottom end at one and a half every thing was going well but the engine started leaning out and cut out leading to my first auto but having now striped out the engine and removed the carb i have noticed the bottom end adjusting screw was quite a bit in which would cause it to lean out so a diagram of the carb would help me understand how the carb should work.