These any good

[Streetluge Chris]

Are these any good for a copterx 450 ebay item 250496253106
metal gears

Make Coroan
Dimensions: 23 x 22 x 12mm
Weight: 13.5g
Operating Speed (4.8V no load) : 0.12sec / 60 degrees
Stall Torque (4.8V): 10.2oz / in ( >2 kg/cm )
Temperature Range: -30 to +60 Degree C
Dead Band Width: 4usec
Operation Voltage: 3.5 - 8.4Volts

[moyesboy]

see this post on a problem with cheap servos!

[Holst]

They will work.

I paid £30 for three 65MG second hand so for £10 more you could get some known good servos. I would prefer these as you can buy spare cases and gears if you break them as well.

But on a budget those servos will be ok, at least you get a fourth one as a spare.

[Streetluge Chris]

Hitec can be the only one to make good servos and more that are any good for a 450.
I see where your coming from with the cheap ones buying all hitec will cost more then the copterx new

[Streetluge Chris]

Ok how about this one JR DS285

[Holst]

Hitec can be the only one to make good servos and more that are any good for a 450.
I see where your coming from with the cheap ones buying all hitec will cost more then the copterx new

From the specs those servos should work fine... (the JR or the cheap ones)

I wasnt trying to put you off, but if your buying an unknown quantity then they might be great servos.. or they might break after a few flight.

You pays your money and makes your choice.

for me I would spend the extra on the Hitec, but if your on a tight budget get the cheap ones and see how they work.

The JR will probably be more reliable and you can upgrade them to metal gears if you break them.