gy401 problem

[loopking]

i have a gy401 which when swiched on the light is solid red but after a few minites flying the tail wont hold and starts waging after landing have noticed that the light is now flashing any idears why this is
regards loopking

[Brian Gifford]

Sounds like it's going into rate mode rather than HH> First step, rebind your Tx & Rx - sounds funny, but often works. HTH.

[loopking]

cant do that as running on 35meg it goes into hh on start up everytime but then after a few min light starts to flash even if you havent flown it

[sacko]

You have any trim on the rudder?

All switches on the tx in the correct position?

[Dannyyy]

make sure you have no subtrim... and no trim on the tail when you pulg the battery in.

[loopking]

all my trims are at zero

[waveydavey]

Same as above it sounds like there is trim on the channel and it isn't initialising correctly, have a look here for instructions.

Click Here Swift GY401 Setup

[loopking]

have got it sorted it was the reciever playing up fitted new one all is now good
thanks for all you help
loopking