Tweet
i had some time on my hands so went to the work shop to spin some alloy bungs
-
-
Cool!
You should sell some - might help finance your repair costs?
Martin
Most of the Aligns, fair few Spektrum bits, bunch of Align & HiTec servos, OBE, VD & Bar.
-
dont mention repairs what she dont know ...................cant hurt meOriginally posted by Mart61 View PostCool!
You should sell some - might help finance your repair costs?Comment
-
Nice job
I have tried to do this before but without a proper doming tool its hard to get 4-off the same by eye. I see that you have done them as more a rounded off chamfer, and it looks really good.
Tim.Comment
-
angle cut at 40 degrees then fine file to shape a quik going over with wet n dry paper dipped in light oil then polished with soval autosol............Comment
-
good old solvo autosol,can remember putting about two hour per wheel on my grasstrack bike with that stuff...Comment
-
Nice. I think you'll have a market for these.Comment
-
i did concider that but there are so many different sizes and i need the internal and external diameters of the skids........mine are on a raptor 30 fitted with heavy duty landing gear from midlandsOriginally posted by shuglu View Post
skid internal dia 10mm
external dia 11.8mmComment
-
humm i would have soom of these of you if you was to sell them
how much would you sell them for?
thanks best regards liamTaort 450 pro v2 fbl
mz18
proud owner of 2 egs
sponsored by :
KBDD International Pilot
Comment
Comment