spinning honey bee

[dandeman]

My honey bee king 2 wont stop spinning Im sick of it
Adrian had a go at trying to make it work when he come over, but no luck. They gyro is working the right way, and everything is working as it should, but why wont it stop spinning Adrian said it could be i need longer ball links as the metal upgrades may be shorter or something. So i had a look at the origional plastic one, but this is the same! Adrian recomended to put longer ball links on, but there must be a reason why Do you know, what my problem is

[Dannyyy]

I have a king 2, and i had this problem, what i did was i got a imax g192 gyro much better, the stock gyro is poo, a cheaper way is to read the manual and mess about with the gain and servo, its on page 13 and 14. On page 14 make sure you take a good look at Fig 1,2,3,4 make sure it look just like that on your king


Hope this helped, Danny

[mattydred]

put your rudder trim in the middle and stop it spinning by sliding the tail servo up or down this boom which ever way it needs.

cheers

matty

[dandeman]

When its spinning i give it full right but it still spins, just a bit slower, and its going as far as it can. I am going to try swap it for another gyro which is different to the one on there at the moment! I will get back to you if it works later. Thanks for all the help.

[unwind-protect]

1) Try here: http://www.rcheliaddict.co.uk/f99/ta...belt-cp-15923/
2) Not that? You can get a little more travel by looseing the ball-link screws to the tail rotor blade grips ever so slightly, so they don't bind.
3) Didn't help. Try a bit more head speed.

[mattydred]

1) Try here: http://www.rcheliaddict.co.uk/f99/ta...belt-cp-15923/
2) Not that? You can get a little more travel by looseing the ball-link screws to the tail rotor blade grips ever so slightly, so they don't bind.
3) Didn't help. Try a bit more head speed.

i have just read the belt cp spinning thread - dan make sure you have a good read

[heliward0]

twist wrong in tail belt????!!??

[squeaky pete]

still got problems with it dan?

[sas]

i had the same thing on mine you have to make sure the tail blades are tight on the honey bee king and that they are on the right way as some tell me that theres were on the wrong way make sure the belt is tight and not slipping off when you set every thing up set the hov-pit at about 10 oclock and the pit-trim at 2 oclock gyro.sw down the gyro should be in rev mode..