Receiver swap issues

[chopperboy]

Chaps,


I have swapped out my AR6200 for an AR6100 as the 6200 aerials need repairing. I re-bound with the receiver and went for a flight.


Ocasionally the heli seems to rotate slowly like the HH is not working correctly. I checked in rate mode and all was fine. Back to HH and sometimes when I power up I see the tail servo run over to the boom side of the slider and the heli seems to rotate slowly requiring correction from me.... when in flight.

It doenn't always do this though?

any ideas, my 6200 never did this.


ta


James.

[Tim Procter]

Highly unlikely its anything to do with the receiver.

Go through the gyro setup routine on your heli and make sure everything is ok and nothing has had a nudge when you have been fitting the new receiver.

[Bauerjack]

Mine did this too, I have to engage the 'gear' switch on my controller - I have to do this for one of the blade 400's and the protos.