Tweet
what should the range before servo jitter hapens with antenna down be?
I have issues with my trex helli standard frame material not cabon. with an old standard ppm 35 meg hiteck trany I get better antena own rang than with a new hiteck eclipse 7 with the same ppm rx and xtal set ,both are verry limited about 6 meters and 8 meters.
With a pcm rx and xtals the eclipse 7 is slightly better about 10 meters but still verry poor .
antena up i get periodic glitching with eclipse at a verry limited range .
I have ferite ring on esc rx lead a good castle creations esc sensebly routed cables and have seperated esc and motor from antena and rx as much as poss
does any one know if its likley I have a bad tx or what its brand new so un tested on other aplications
I have issues with my trex helli standard frame material not cabon. with an old standard ppm 35 meg hiteck trany I get better antena own rang than with a new hiteck eclipse 7 with the same ppm rx and xtal set ,both are verry limited about 6 meters and 8 meters.
With a pcm rx and xtals the eclipse 7 is slightly better about 10 meters but still verry poor .
antena up i get periodic glitching with eclipse at a verry limited range .
I have ferite ring on esc rx lead a good castle creations esc sensebly routed cables and have seperated esc and motor from antena and rx as much as poss
does any one know if its likley I have a bad tx or what its brand new so un tested on other aplications