If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have just got an eagletree logger and a couple of sensors. I have noticed that you can measure the servo command using the logger, there is a y-cable available for sale, but I was wondering if you can use any normal y-cable?
Regards,
Jason
Futaba 12FG/ Knight 3D / 450Pro / Beam E4 and a whole load of gliders!
Tweet
Comment