If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
just a battery question,i connected my lipoly to the chopper with the wrong polarity,reconnected properly but not a sausage,anyone know if the 4in1 rx etc,has diode protection or is it knackered
cheers
Dave's right. Reverse polarity usually means a dead ESC. You will find it will have a protection diode which would have blown. Take it back to the shop and plead ignorance. They might replace it.
chappers i bought 1200ma batteries from the states,
they are different connectors,
stripped the unit down noticed burnt area next to battery connector
there was a copper strip not in the printed circuit but on the top of the board this was severed so i have soldered a thin strip of wire in
between the two halves and lo and behold it works again
Comment