Tweet
If anyone has a Align Trex 700 DFC main shaft ( H70093 ) could you please measure the distance between the shaft bottom hole centre ( where the auto tail drive gear bolt fits ) and the edge of the shaft raised partition where the shaft sits on top of the upper bearing block, this information will assist me with prospective modification I am hoping is around 102MM.
-
-
I have the 700 FL shaft on a heli. I would think the dimensions below the upper bearing block would stay the same?Kasama, Minicopter, Henseleit, JR, Shape, Beam
Robbe, RMJ Raptor gasser, powered by
Spartan, Spirit, BeastX, Kontronik, CY Total-G, DX8
member of Epsom Downs and Bloobird clubs
Proud recipient of 7 EGS!
and a platinum star 
-
I am hoping that the 700FL shaft and rotor head will fit the DFC frame hence the question as the lower portion of shaft is more important.Last edited by lae88; 19-10-2019, 12:48 PM.Comment
-
I have a DFC head on the FL shaft and another heli with the FL head but I don't know exactly what shaft it is because I can only see 'Align 700' and if there's anything else written on there it's inside the one-way assembly.Kasama, Minicopter, Henseleit, JR, Shape, Beam
Robbe, RMJ Raptor gasser, powered by
Spartan, Spirit, BeastX, Kontronik, CY Total-G, DX8
member of Epsom Downs and Bloobird clubs
Proud recipient of 7 EGS! and a platinum star Comment
-
102 ����
Ps sorry maj had to dig through these to find your parts ��Last edited by Kiwi64; 19-10-2019, 02:50 PM.Love the smell of 2stoke in the morningComment
-
Thank you all , as per picture there are two 700FL shafts the H70H003XX is a bit longer for the third bearing block so that one should hopefully fit the DFC airframeLast edited by lae88; 19-10-2019, 04:25 PM.Comment
Comment