Tweet
I am trying to setup my Talon 90 endpoints with the VControl but i am unsure of how to do it. With my other Castle esc's i have just set the endpoint to 30 with my receiver pack connected. Then i connect the esc lipo's and move the endpoint up until i get the beeps. But with the talon and the build in bec i have to fully shut down the model so it will not work this way. Anyone setup one before and can help me?
-
Surely you just use the Castle ESC wizard in the V Control?
Not done a Castle myself with the wizard. I'm running Vbar governor on my Castles which is fit and forget so far as endpoints go.Current fleet: Goblin Thunder Sport (700), Trex 700L, Logo 600, Specter 700, Henseleit TDR, V-Baaa control.
Next heli: I have pretty much everything I want. Maybe I'll upgrade some electronics or something. -
Esc wizard as above just follow on screen prompts.sigpic
Rave ENV Nitro
New Logo 550
Synergy N5c
TSA 700E night flier
I use VBar control because it's feckin awesome I use NEO rescue when I remember to
5 x EGS thingys and a Platinum star doo dahComment
-
The castle esc wizard just shows a picture of a QR code and say go to their website.Comment
-
i only use Kontronik and the setup is easy peasy?Originally posted by CromedCm View Postsigpic
Rave ENV Nitro
New Logo 550
Synergy N5c
TSA 700E night flier
I use VBar control because it's feckin awesome I use NEO rescue when I remember to
5 x EGS thingys and a Platinum star doo dahComment
-
QR code should take you here:
Castle Helimode with Governor | VStabi
Which has full instructions on setting up the Castle governor.Current fleet: Goblin Thunder Sport (700), Trex 700L, Logo 600, Specter 700, Henseleit TDR, V-Baaa control.
Next heli: I have pretty much everything I want. Maybe I'll upgrade some electronics or something.Comment
-
You can set it up for other ESC in the V control wizard.
Once you have it set up go to the set up governor menu and select external governor and set your end points to 30 on the high speed and 30 on the low speed.
Then
you need to calibrate the castle throttle to the V control, this is done by putting the throttle to high stick during the above end point setup menu then power on the model and adjust the high range from 30 towards 100 until you hear a confirmation beep then add 2 more clicks to it.
You then have to move the throttle stick to the lowest point and move the low limit from 30 towards 100 until you hear a confirmation beep then again add 2 more clicks.
Now the throttle is calibrated to castle so now you can set each bank to 30, 70 , 100 and it'll work with castle governor assuming you have it selected correctly in the castle software set rpm setupComment
-
Just seen above post by bigpops which is probably easier but both will work fineComment
-
Pretty sure i have it correct now
Thanks guys!
Comment
Comment