Universal discharger from Perfect Regulators

[Mike Sanders]

I haven't got a photo at the moment but it is a Lantian buzzer as sold to go on quads as a lost model sounder. I have looked it up. It is 5 volts.
It doesn't have any plugs or other connector. The instructions make no mention of it.

[acidla]

The buzzer goes on the negative side of the discharger.

[acidla]

The buzzer goes on the negative side of the discharger.

If you got this one

[coolice]

The buzzer goes on the negative side of the discharger.

Those perfect regulator's units are quite smart, but I still can't understand why they didn't make a case for it.
Heat wouldn't be an issue with cooling slots, but it would just protect the exposed pcb if anything fell on it...... such as a screwdriver while it was on your bench.

Ian

[acidla]

Those perfect regulator's units are quite smart, but I still can't understand why they didn't make a case for it.
Heat wouldn't be an issue with cooling slots, but it would just protect the exposed pcb if anything fell on it...... such as a screwdriver while it was on your bench.

Ian

I love it.
Yes it is exposed and for that reason i place it on a table with nothing around it.

[Mike Sanders]

Mine isn't a Perfect Regulator unfortunately. It is a cheap Chinese balancer with three light bulbs. The lipo gets connected to a piece of electronics which is connected to the three bulbs. It is connected to the balancer by a small wire. The balance leads of the battery plug into the balancer just like with an ordinary lipo tester.

[acidla]

Mine isn't a Perfect Regulator unfortunately. It is a cheap Chinese balancer with three light bulbs. The lipo gets connected to a piece of electronics which is connected to the three bulbs. It is connected to the balancer by a small wire. The balance leads of the battery plug into the balancer just like with an ordinary lipo tester.

It is also a solution

[Mike Sanders]

I made up a little stand for my discharger and here is a picture of it in action.