Which hv servos

[moggyp18]

Im looking at doing a gaui nx4 build but im not sure what servos to go for ??? im after high voltage which can be run unregulated straight from a 2s rx pack so cutting out the need for a regulator.

anyone got any suggestions which ones to go for or to avoid !!!!!

thanks

mick

[ragge1]

take a look at RJX

[stargazer]

MKS Servos,as below,that were in my Gaui Nx4.

[Planehazza]

Futaba 272SV from RC Japan. Full set for under £200. Would be double that buying within UK...

[GIXERMAN]

Futaba 272SV from RC Japan. Full set for under £200. Would be double that buying within UK...

aren't they full-size servos, sure nx4 is midi size. could be wrong

[ragge1]

so the gaui nx4 uses minis , I've been using RJX FS0391HV on my HD500 and did have them on my G500 , they have been great for me , just a thought

[cycled]

Or get some KST 589 / 565X / 515 (ebay link). KST always seem to get pretty good reviews, though they're not quite as cheap as they used to be with the weak pound.

[Planehazza]

aren't they full-size servos, sure nx4 is midi size. could be wrong

Woops, serves me right for skim reading it.

[moggyp18]

Thanks for all the input guys your suggestions have given me something to look into !!! If I'm honest I quite like the looks of the mks ones but will do I bit of research first before I bite the bullet.

[Yatej]

I have an NX4 with the MKS HV9767 cyclic and 9780 tail, I have no complaints as they work really great with this heli combination...

Just bear in mind you will need a throttle servo installed also that can handle HV as well to run direct of a lipo or you will prob need to run them off a life instead which I did for a while until I put a HV servo on the throttle later on....

That being said the specs & performance of the MKS servos even running at the lower voltage of a life (6.6v) is still a huge huge improvement imo compared to lower voltage servos options.