Revlock-FF9

[mike557]

Hi Guy's
I need help (non medical) Just bought CSM Revlock and after 5 hours of hair tugging I have yet to figure out how to programme ff9 so that the gov will change mode A B with the idle up switch. I know its got to be here somewhere

Anyone got pukka info

Regards

mike

[pgaryga]

Hi Mike,

I have mine setup as follows on the Govenor screen:

Page (1/2)

RATE-UP > 67.5%
CNTR > 21.0%
DOWN > 21.0%

SW > E

Page (2/2)

MIX > ACT
CUT-CH > CH7
DIR > +Limit

I have also used Prog.Mix1 to use VR3 to trim the headspeed (never had to change it though). Prog.Mix2 is setup to use switch A to disable the gov.

Ch7 (Aux1) end points are both set to 100%.

This is on a T9CHP super.

Hope this helps,

Pete.

[mike557]

pgaryga

cheers for that will give it a whizz. With any luck the *^&%$** weather may let me out to play tomorrow

Regards
Mike