Tweet
Just found this notification regarding the tail blades on the recently released OXY3 and thought I'd let you guys that have them know in case if you haven't been notified.
A notification about the OXY3 Kit!
Subject: Oxy3 advisory #1
Our Oxy3 has been selling beyond expectation. We are excited to see so many at local flying fields!
We have discovered a small issue with some Oxy3 47mm tail blades. Some sets of blades included in our kits were not balanced before leaving the factory.
Because we wish to support our customers, we will be sending all registered owners a new set of 47mm tail blades, free of charge. These new blades are also further optimized in design.
Additionally, we have updated the standard tail ratio by changing the stock tail pulley from 14T to 15T. This slightly slows down the tail rotor, which is appropriate if you are running head speeds greater than 4000rpm. We will include this 15T pulley when we send registered pilots the tail blades.
We advise you to change the tail blades immediately and dispose of the old ones. However, the tail pulley only needs to be changed if you are running high head speeds.
Please register your Oxy3 Register ‹ OXY Helicopter to receive your new tail blades and tail pulley.
A notification about the OXY3 Kit!
Subject: Oxy3 advisory #1
Our Oxy3 has been selling beyond expectation. We are excited to see so many at local flying fields!
We have discovered a small issue with some Oxy3 47mm tail blades. Some sets of blades included in our kits were not balanced before leaving the factory.
Because we wish to support our customers, we will be sending all registered owners a new set of 47mm tail blades, free of charge. These new blades are also further optimized in design.
Additionally, we have updated the standard tail ratio by changing the stock tail pulley from 14T to 15T. This slightly slows down the tail rotor, which is appropriate if you are running head speeds greater than 4000rpm. We will include this 15T pulley when we send registered pilots the tail blades.
We advise you to change the tail blades immediately and dispose of the old ones. However, the tail pulley only needs to be changed if you are running high head speeds.
Please register your Oxy3 Register ‹ OXY Helicopter to receive your new tail blades and tail pulley.