os50 throttle linkage

[bumps]

hi there

ok here we go setting up throttle linkage trex600n
curve for test is 0-100 full open full closed were should the line be on the carb
ie first / second or thid mark on the body at 50% stick i should now but the brain has fallen out


thanks

[waveydavey]

I think you'll find if you have equal endpoints top and bottom the 50% will be between the middle and higher mark. I wouldn't worry too much about it though you wouldn't know if it was on the middle line or the top line theres such a large range. Do you use a governor? The important bit is to make sure the linkage at 50% is at right angles IE servo horn and throttle input horn are parallel and of equal spacing. So if it's 13mm on the servo make sure it's the same on the throttle horn

[bumps]

iam setting it as above with the th trim at the bottem so when centerd it should give an idel point
is this wright when centerd it on the third mark yes i do use a governor not all the time

thanks