If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Pretty flash, don't think it beats the vid of Eric Larson doing an auto onto a table with an MS hornet... Unfortunatly his site seems to be down at the moment, anyone remember his hornet videos?
Best one i saw was at last years 3D masters, when Jason Krouse Went really high cut the engine and held it up there until the blades stopped, then got the blades back up to speed with a very quick desent, amazing, the crowd went wild
James Sponsored by Align-Trex.co.uk Optifuel/optipower MKS servotech
While I haven't seen that vid yet (try to remember tonight) I think the best I've seen so far was an iverted auto, but he landed on the blades without breaking any. THAT was impressive.
While I haven't seen that vid yet (try to remember tonight) I think the best I've seen so far was an iverted auto, but he landed on the blades without breaking any. THAT was impressive.
Best one i saw was at last years 3D masters, when Jason Krouse Went really high cut the engine and held it up there until the blades stopped, then got the blades back up to speed with a very quick desent, amazing, the crowd went wild
Pretty flash, don't think it beats the vid of Eric Larson doing an auto onto a table with an MS hornet... Unfortunatly his site seems to be down at the moment, anyone remember his hornet videos?
Ade and Richie had an Auto Off last year which involved landing on a table, i won't say who won
LOL you realy know how deep to put that Knife in phill
Actualy it was because of this very video that was posted sometime last summer that the table Auto invent at DMHC took place.
Martin
Comment