Need a little help

[Bell47G]

I have a mini titan V2 & bought a Etronix headlock Gyro ET0080
The tail has very slight movement left & right.
when you get to the point of lift off it just spins around. I have tried reversing the gyro, still the same?
i just don't know what to do?

[GIXERMAN]

Spin head by hand and make sure tailblades on correct .

fold one tailblade move rudder stick left, tailblade should point to boom.

With your index finger and thumb hold tail shaft , move nose to left and should pinch your fingers . Which means all is good

[Bell47G]

Spin head by hand and make sure tailblades on correct .

fold one tailblade move rudder stick left, tailblade should point to boom.

With your index finger and thumb hold tail shaft , move nose to left and should pinch your fingers . Which means all is good

Done all that the only thing when you move the tail Nothing else moves not Evan the tail?
Evan tried a different gyro and still the same.. Take out the yellow gain wire and seems fine? But no hold?

[GIXERMAN]

Never used that gyro, just read spec quick, if you disconnect gain wire, adjust pot on top of gyro. Which tail servo you using with it. 760 1520 frame rate

[Bell47G]

The yellow gain wire disconnected states only for a 4 channel.
but when connected slight movement with stick imput!
remove wire, full control on stick movement but no hold. Moving nose left & right nothing?
Only adjustment is on the gain then nothing, no reaction?

[GIXERMAN]

Unless the gyro isn't comparable with servo maybe.

as previous question which tail servo you using ?

[Bell47G]

Unless the gyro isn't comparable with servo maybe.

as previous question which tail servo you using ?

Trex 420 tail servo, also tried different servos like eflite & new power XL9 metal gear.

Been through all the Gain settings, the best setting I've got is 23.5% HH.
But as soon as it leaves the ground it spins around!
The conclusion is the new! HH gyro is not HH?
Get what U pay for I suppose!!

[Bell47G]

Been through all the Gain settings, the best setting I've got is 23.5% HH.
But as soon as it leaves the ground it spins around!
The conclusion is the new! HH gyro is not HH?
Get what U pay for I suppose!!

[Bell47G]

From My last post having trouble with new Gyro.
I put on my spare Eflite G110 Gyro from the Eflite SR, gyro in reverse tx gyro Reverse gain settings down to 20% HH, and it flys again.
but with the odd twich but expected. New Gyro not as expected.
thanx GIXERMAN for your imput!