Help with Blade 300x and AR7200BX setup

[jjjjdup]

Hi Guys

My 300x seems to spin around in a circle when spooling up.

Must be some setting on the RX.

Anyone in Kent near Gravesend who knows how to setup a AR7200BX who would be so kind to look at my heli.

It would be much appreciated.

Thank you.

[GIXERMAN]

i would say your gyro is compensating the wrong way

[Heliben]

sounds like your tail is correcting the wrong way.when you hold it and turn the nose the leading edge of the tail blade should move towards the direction that you turned it. if its not then you need to reverse the tail in your beastx

[jjjjdup]

Thanks.
I have downloaded the instructions, but it seems quite intimidating.
How do I do it?

[PaulJC]

Setup Menu > LED F

[jimmyhorns]

If you factory reset the AR7200bx, the ones shipped with the 300x revert to the standard settings for the 300x.

[jjjjdup]

I had to reverse the rudder gyro, so Im quite confident it is correcting the right way now as it is now doing what heliben posted, but still spinning.
i have noticed there is very little throw on the rudder servo.

[PaulJC]

Are the rudder servo end points set correctly in the AR7200BX, it sounds like you need to go through the whole setup procedure again.

[jjjjdup]

Also. I did set the end points but stull little movement.

[jjjjdup]

Someone mentions to adjust gyro settins in the tx?

[jjjjdup]

Sorted( to some extent. )
Default gyro on 11x was 50%
Upped it to 54 %
Now working OK but perhaps not a optimal setup and I still have tons to learn.
Thanks everyone with the advice

[jjjjdup]

Is this right.
even on 54% it was still rotating very slowley. I have upped it to 63% and it seem to stay in one place now.
is that how gyro settings work?