Swash plate problem on Belt CP

[VaNDAL_UK]

Right finished and tided up

Swash plate and throttle up all going in the same direction so do the blades, so this little F$£%er will lift now, YAY!!

Going to test it out tomorrow. Been trying to get my head round the whole Head Lock gyro thing... I think I have it sorted now?!?

I got a swivel chair without the back so I'm going to strap it to that and test the tail before doing the real thing.

Boggy:

Your right about the manual. I was reading it earlier just for a laugh. According to the manual "you should not fly lonely"

[Boggy]

yep words of the funny are many good luck with the flight

[VaNDAL_UK]

Right well after sorting the servo problem and setting up the buzzflyer head hold gyro I managed to hover it in my spare room with great sucess! the head lock gyro REALY holds it solid!! So I though I'd take it outtside, it was a bit gustly so I though "bahhh it will be ok".. WRONG 6" off the floor small gust.... blades hit the tail boom, Stuff start eject from the chopper!!!

x1 boom
x1 feather shaft
x1 boom support
x2 blades
x1 horizontal fin
x1 flybar
x1 esky servo

Not bad for a stoopid mistake! Any way all parts on order for hong kong, heli stripped, cleaned and ready for a good rebuild.

I was wondering if anyone has used the Esky 0406A transmitter on Reflex XTR? I'm going to make up a cable and try it anyway.