Announcement

Collapse
No announcement yet.

My heli movie

Collapse
X
Collapse
 
  • Page of 2
  • Filter
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • #16
    i did cut the minor crashes out

    done a few minor upgrades today ally lower rotor head and bearing holder
    and broke a skid bent the fly-bar yesterday so got new 1's today so i could fly also using both links on the fly-bar now ....

    Was having a fly today and still got into trouble in my back garden (no wind ) and now i'm in need of new body work and more skids it got to close to a fence and fell from about 8ft
    Danny
    London model heli flyers

    I am learning all the time. The tombstone will be my diploma. ~Eartha Kitt

    Blade Mcx
    Blade 400 with 3 x hs65mg's, Gy401 with fs61bb tail, 450 canopy
    Yellow 600 nsp 451's on cyclic, 251 on tail with Spartan ds760 ,ds620 on throttle,Spectrum ar7100 + csm carbsmart
    Accu RC / Phoenix sims
    Spectrum Dx7se
    F16 edf
    Mavic Pro
    Spectrum DX8 dsmx
    Blade 230s v2
    http://pic7.piczo.com/Carpman68
    www.dannycablephotography.co.uk

    Comment

    • #17
      You are doing great mate never tryed one of those helis before but had a humming bird v3 and it got a few hammerings including landing in a ditch a foot deep in water and it dried out and still workes . make sure the sink plug is out .
      REGARDS JAMIE

      Knight 50,50 hiper,hatori pipe,gy401+9254,ttcarbon blades futaba ff7fast 2.4 ghz set up with 3152 digi s all round and a rev loc 10
      450 rex standard setup
      Phoenix sim...
      Plus two gliders and one pits special biplane

      Comment

      Previous 1 2 template Next
      Working...
      X