twister 3d wobble

[martnslater]

hi all
i have got a twister 3d and all seems ok untill it just gets about a foot off the ground the the heli starts to wobble and shake its had no crashes or hard landings so can anyone come up with a solution it could it be down to the head speed thanks martyn

[David Drew]

Stay off the booze & get control of your fingers back

Happy Christmas

David

..sorry no idea personally. But the experts are not far away.

[ChrisB]

It sounds like the headspeed is too low,is it new or have you been flying it before,if it was Ok and isnt now i would suspect the Lipo,if the Lipo is known to be good try and increase the throttle curve

[David Drew]

Stay off the booze & get control of your fingers back
David

I withdraw that. It's Christmas. Have a few.

[martnslater]

lol
i will
have a few that is

[David Drew]

lol
i will
have a few that is

Mart,

I went flying last weekend after a long time without stick-time. It was freezing and I had gone back miles in confidence. I had no confidence to do anything new & I couldn't decide what was causing the helis to be 'less stable' that before....cold, lack of stick time ...or a few beers the night before.

To be honest, it was almost certainly the night before

Hope you get it sorted soon.

All the best

David

[martnslater]

hi dave
defo not the beer mite have the shakes over crimbo ,but honesly doing my head in been through all the possibiltys blades balance bent main shafts you name it ihave checked it so it all points to the head speed hope i am right

[martnslater]

ps have a gud un

[nightstalker]

Hi mate i had one of theses helis and i found to sure the wobble was to run 100& throttle curve also the main shaft is hallo and it can bend very easy so easy you dont even have to crash it to bend it, just strip the main shaft down and roll in on something flat

[xygax]

throw the main shaft in th ebin and make one from a bit ov silver steel the ally one is terrible...
steve