How do i use these

[richie_jones]

Just found these in my box of bits that came with the heli..

What are they for and how do i use them .
Think they have something to do with setting up..

Cheers


Sent from my GT-I9300 using Tapatalk 2

[tonystevens]

they are headloaders. Use them inplace of the blades when you want to bench test your heli or engine.
Never used then myself, never needed to but remember if you do use them to take your tail blades out too!

[Paulice]

They are head loaders you fit them like blades and run up the Heli to full speed. Back in the early nitro days, to set full throttle.
Now they never get used.

[dave j]

As has been said there headloaders for use when setting up nitro heli engines

[xygax]

not for electrics...

Steve

[richie_jones]

Thanks for the replys guys

How come there no longer used?

Sent from my GT-I9300 using Tapatalk 2

[Steve]

if you do use them to take your tail blades out too!

I've seen head loaders used quite a few times, and the tail blades have always been left on. Makes little difference as far as I can see.

[tonystevens]

I've seen head loaders used quite a few times, and the tail blades have always been left on. Makes little difference as far as I can see.

yes until you hit the rudder stick by accident lol

[Steve]

yes until you hit the rudder stick by accident lol

Voice of experience maybe?

Lol.

[del19_82]

Thanks for the replys guys

How come there no longer used?

Sent from my GT-I9300 using Tapatalk 2

They don't get used as most guy's will do their tuning while the model is flying, ie, fly, land, test backplate, tune, fly and so on. General consensus is that it's better to do your tuning etc this way as it's more of a realistic load on what the heli will be doing rather than on the deck with headloaders

Hope this helps

[tonystevens]

Voice of experience maybe?

Lol.

Yes lol, but without headloaders, it wasnt too bad but could have been alot worse!