Blade 400 3D - Airborne without crashing!

[Holst]

Yeah if worst comes to worst I'll get my junior hacksaw or grinder onto it

Whatever you do dont be tempted to pull hard on the bearings or you will damage them.

If the shaft is already no good then you may as well hack it up to save the bearings

[dam74]

Yeah I think I've ******* one of the bearings. Question is are the gearbox bearings part of the casing or do you just buy them seperately and replace?

[Holst]

Yeah I think I've ******* one of the bearings. Question is are the gearbox bearings part of the casing or do you just buy them seperately and replace?

They should be avalable seperately.
Fastlads have bearings on there spares list, just measure the ones you have to get the correct size.

[dam74]

Was considering just ordering a set of each to have a few bearing spares. Pretty much have a complete set of spares at the moment if I get the spares required to do the tail section.