Help with Blade 400

[Russ The Chippy]

Hello,repaired blade after first outing which included main gear and feathering shaft but now when i push the throttle up it will fire up for about 2 seconds then die pull the stick back and push up again it does the same thing over and over,battery fully charged....any idea`s would be welcome.Cheers

[spunkmyer]

I've seen you esc thread but keeping things opened minded as you have done a repair, have you made sure that nothing is binding from the crash or a part that has been replaced is maybe binding somehow,

I'm just thinking this could be over stressing the esc or batt or even the motor?.

[brin]

why open another thread. now we know you have had a crash we can look for other reasons.

[Russ The Chippy]

still learning helicopter and forums i`m afraid so apologies for that,any idea`s on what may be binding or causing extra load.

[brin]

if you crashed and didn't cut the throttle it could have damaged the motor or esc .

[brin]

you wont find any thing in the book if you post up what esc it is i am sure someone will post up a link to the manual.

[Russ The Chippy]

looked on ESC and it says E-Flite 25 amp heli brushless ESC part no. EFLA325H. anything else to check?

[airtime0007]

looked on ESC and it says E-Flite 25 amp heli brushless ESC part no. EFLA325H. anything else to check?

If nothing is binding i reckon the esc was fried in the crash. you said it went in to a hedge i think, did you cut the throttle? Ive got an align £35 amp on mine and have never looked back. I should just do that mate there cheap enough. I have a spare stock one could have if it helps. I ve never used it but was told it works fine p.m if you need it

[airtime0007]

I ve just noticed you re in bournemouth, Im near shaftesbury,not far