GWS ESC problem

[gary911]

Hi, can anyone help please? I have fitted a new GWS ESC to my Zagi but the motor is now running in reverse. I am using Sanwa RD 6000 sport TX with a Sanwa RX 611 single conversion, and I have carried out all the wiring as per instructions, it all worked fine, prior to the installation of the new escape. Ailerons work fine but I am baffled can you please help. Thanks, Gary.

[Boggy]

swap any two wires to the motor around

[gary911]

hi thanks this is a brushed motor so just red and black wires so is it ok to change polarity. regards gary

[Boggy]

ah sorry dude i stupidly assumed it was brushless without asking!
my knowledge of brushed motors is limited but ive just swapped the wires on an rc buggy i have and it goes backwards so hopefully its ok to do it

the wires from my esc are red/black the motors are yellow/green so there are no polarity markings on it. i built it a few years ago and cant remember if it was trail and error or as per writen instructions to connect it originaly