Tweet
Raptor 30 clutch
Hi all i have a bit of a problem with the clutch on my raptor, i fitted a quick heavy duty clutch and changed all the starter shaft and clutch bell on my v1 to v2 parts,
Problem seems to be that the clutch does not seem to fully engage, the blades start to go round as normally but not reach full hover speed. Then as i let it return to tick over the blades will stop as expected but then start to go the opposite way and the only way i can stop this is to stop engine and re-start. i was thinking that the clutch i purchased off quick was for the v1 and now that i have changed the bell and other bits to v2 that the v1 clutch is a little bit smaller. Thus not getting a good bite on the lining in the v2 bell.
Upon checking there is no contamination and all parts are secure when fitted.
Problem seems to be that the clutch does not seem to fully engage, the blades start to go round as normally but not reach full hover speed. Then as i let it return to tick over the blades will stop as expected but then start to go the opposite way and the only way i can stop this is to stop engine and re-start. i was thinking that the clutch i purchased off quick was for the v1 and now that i have changed the bell and other bits to v2 that the v1 clutch is a little bit smaller. Thus not getting a good bite on the lining in the v2 bell.
Upon checking there is no contamination and all parts are secure when fitted.
Comment